Veritas NetBackup™ for Hyper-V Administrator's Guide
- Notes and prerequisites
- Configure NetBackup communication with Hyper-V
- Configure NetBackup policies for Hyper-V
- Backup options on the Hyper-V tab
- Hyper-V - Advanced Attributes
- Browse for Hyper-V virtual machines
- Configure Hyper-V Intelligent Policies
- NetBackup Hyper-V for SCVMM
- Windows Server failover cluster support
- Virtual machine maintenance after a restore
- Back up and restore Hyper-V
- Restoring individual files to a shared location on the virtual machine
- Use Accelerator to back up Hyper-V
- Best practices and more information
- NetBackup logs for Hyper-V and how to create them
- Errors during policy creation
- NetBackup status codes related to Hyper-V
- Appendix A. VSS backup method: Hyper-V online and offline backups
- Appendix B. Hyper-V pass-through disks
- Appendix C. NetBackup commands to back up and restore Hyper-V virtual machines
- Examples of nbrestorevm for restoring VMs to Hyper-V
Enabling VxFI logging
By default, VxFI logging occurs at the error level. You can increase the logging verbosity by changing the log configuration file for the appropriate provider.
To increase the VxFI logging level
- On the Windows desktop of the Hyper-V server where the NetBackup client is installed, go to the following location:
\Program Files\Common Files\Symantec Shared\VxFI\4\ConfigFiles\
This folder contains a configuration file for each provider, such as vss.conf and emcclariionfi.conf. These files are generated after a successful load of VxFI providers, usually during NetBackup policy validation.
- Edit the .conf file for the appropriate provider, as follows:
Change the TRACELEVEL entry to the following:
The default TRACELEVEL value is 00000001.
Note that VSS and WMI provider logs are relevant to Hyper-V.