Please enter search query. Search <book_title>...
Veritas NetBackup™ for DB2 Administrator's Guide
Last Published: 2021-06-07
Product(s): NetBackup (9.1)
- Introduction to NetBackup for DB2
- Installing NetBackup for DB2
- Verifying the operating system and platform compatibility
- About log archiving
- Configuring NetBackup for DB2
- About configuring a backup policy for DB2
- About adding backup selections to a DB2 policy
- About backing up archive log files with the user exit program
- Configuring the run-time environment
- Creating a db2.conf file for use with the user exit program
- Creating a db2.conf file (vendor method)
- Configuring bp.conf files in a cluster environment
- About NetBackup for DB2 templates and shell scripts
- Creating DB2 scripts manually
- Performing backups and restores of DB2
- About user-directed backups
- Performing a database restore
- Using the NetBackup for DB2 recovery wizard
- Using DB2 to perform a restore
- About an alternate restore
- Using Snapshot Client with NetBackup for DB2
- About NetBackup for DB2 with Snapshot Client operations
- Restoring NetBackup for DB2 from a snapshot backup
- About configuring NetBackup for DB2 block-level incremental backups on UNIX
- Configuring policies for BLI backups with NetBackup for DB2
- About Snapshot Client effects
- Troubleshooting NetBackup for DB2
- About the NetBackup for DB2 log files
- Appendix A. Configuration for a DB2 EEE (DPF) environment
- Appendix B. Using NetBackup for DB2 with SAP®
- Appendix C. Register authorized locations
Setting the debug level on a Windows client
To control the amount of information that is written to the debug logs, change the Database debug level. Typically, the default value of 0 is sufficient. However, technical support may ask you to set the value higher to analyze a problem.
The debug logs are located in
Information from both the Verbose and the Database debug settings is logged to the same file, mmddyy.log
To set the debug level on a Windows client
- Open the Backup, Archive, and Restore interface.
- Select File > NetBackup Client Properties.
- Click the Troubleshooting tab.
- Set the General debug level.
- Set the Verbose debug level.
Set this level to adjust the amount of information from the user exit program.
- Set the Database debug level.
Set this level to adjust the amount of information from the NBDB2 vendor library.
- Click OK to save your changes.