Veritas NetBackup™ for DB2 Administrator's Guide
- Introduction to NetBackup for DB2
- Installing NetBackup for DB2
- Verifying the operating system and platform compatibility
- About log archiving
- Configuring NetBackup for DB2
- About configuring a backup policy for DB2
- About adding backup selections to a DB2 policy
- About backing up archive log files with the user exit program
- Configuring the run-time environment
- Creating a db2.conf file for use with the user exit program
- Creating a db2.conf file (vendor method)
- Configuring bp.conf files in a cluster environment
- About NetBackup for DB2 templates and shell scripts
- Creating DB2 scripts manually
- Performing backups and restores of DB2
- About user-directed backups
- Performing a database restore
- Using the NetBackup for DB2 recovery wizard
- Using DB2 to perform a restore
- About an alternate restore
- Using Snapshot Client with NetBackup for DB2
- About NetBackup for DB2 with Snapshot Client operations
- Restoring NetBackup for DB2 from a snapshot backup
- About configuring NetBackup for DB2 block-level incremental backups on UNIX
- Configuring policies for BLI backups with NetBackup for DB2
- About Snapshot Client effects
- Troubleshooting NetBackup for DB2
- About the NetBackup for DB2 log files
- Appendix A. Configuration for a DB2 EEE (DPF) environment
- Appendix B. Using NetBackup for DB2 with SAP®
- Appendix C. Register authorized locations
Minimizing timeout failures on large database restores
Large database restores sometimes fail when multiple restore sessions compete for resources. In this situation, a restore session can be delayed while waiting for media or device access. If the delay is too long, the restore session times out. Use the following procedure to minimize session timeouts and to allow the restores to complete successfully.
To minimize timeout failures on large database restores
- In the NetBackup Administration Console, expand NetBackup Management > Host Properties > Clients.
- Double-click the client.
- Select the Timeouts properties.
- Set the Client read timeout property to a large value.
The default for the Client read timeout setting is 300 seconds (5 minutes). For database agent clients, increase the value significantly from the recommended value.
See the NetBackup Administrator's Guide, Volume 1.
For example, change this setting to 30-60 minutes to minimize timeout errors.
- Click OK for each client.
This change may delay detecting problems during subsequent backups. Consider putting the original value back in place once any restore that requires a change is complete.