Veritas NetBackup™ for VMware Administrator's Guide
- Required tasks: overview
- Notes and prerequisites
- Configure NetBackup communication with VMware
- Adding NetBackup credentials for VMware
- Validating VMware virtualization server certificates in NetBackup
- Configure NetBackup policies for VMware
- VMware backup options
- Exclude Disks tab
- Configure a VMware Intelligent Policy
- Reduce the size of backups
- Back up virtual machines
- Use Accelerator to back up virtual machines
- Restore virtual machines
- Restoring the full VMware virtual machine
- Virtual Machine Recovery dialog boxes (restore to original location)
- Virtual Machine Recovery dialogs boxes (restore to alternate location)
- Restoring VMware virtual machine disks by using Backup, Archive, and Restore
- Restoring VMware virtual machine disks by using NetBackup commands
- Restoring individual VMware virtual machine files
- Browse and search virtual machines for restore
- Restore virtual machines with Instant Recovery
- Use NetBackup for vCloud Director
- Virtual machine recovery dialog boxes for vCloud Director
- Best practices and more information
- Appendix A. NetBackup commands to back up and restore virtual machines
- Using NetBackup commands to create a VMware policy
- Appendix B. Configuring services for NFS on Windows
- About configuring services for NFS on Windows 2012 or 2016 (NetBackup for VMware)
- About configuring services for NFS on Windows 2008 and 2008 R2 (NetBackup for VMware)
- Appendix C. The Reuse VM selection query results option
- Appendix D. Backup of VMware raw devices (RDM)
Changing the host name of a VMware server in NetBackup
Use the following procedure if you need to change a VMware server's host name as it is stored in NetBackup.
Example reasons for changing the VMware server name are the following:
You used a short host name for the server for its NetBackup credentials, and need to replace that name with the fully qualified host name.
Two hosts currently resolve to the same IP address, and one of them must be renamed and assigned a new IP address.
To change the host name of a VMware host in NetBackup
- Remove the current credentials that were entered for the VMware host.
Do the following:
In the NetBackup Administration Console, click on Media and Device Management > Credentials > Virtual Machine Servers.
Right-click on the credentials definition for the VMware server and select Delete (or press the Delete key).
- In the NetBackup Administration Console, re-enter NetBackup's credentials for the VMware server.
Make sure to enter the correct host name for the VMware server.