Please enter search query.
Search <book_title>...
Veritas NetBackup™ 5240 Appliance Hardware Installation Guide
Last Published:
2020-05-06
Product(s):
Appliances (Version Not Specified)
Platform: Veritas 5240
- Hardware overview
- Preinstallation requirements
- Installation procedures
- Appendix A. Adding one or more storage shelves to an operating appliance that does not have any storage shelves
- Appendix B. Adding storage shelves to an operating appliance that has at least one storage shelf attached
- Appendix C. Adding the disk space of additional storage shelves
Installing the storage shelf rails
Best practices recommend that the storage shelves are installed lower in the rack than the appliance.
There must be a minimum depth of 76 cm (30 in.) between the front of the rack and the rear of the rack. Veritas recommends that two people install the rails; one person at the back of the rack and one at the front. Veritas also recommends that two people lift and place the storage shelf into the mounted rails.
To install storage shelf rails into a rack
- Identify the front and the rear of each rail. The following illustration shows the front of the left-hand and the right-hand rails. Red arrows show the pins that fit into the rack.
- Use the rack templates to align the rails with the rack holes.
- Fold the templates along the dotted yellow lines to match the holes in the rack.
Be sure to use the same holes on each side of the rack.
- Place the left rail inside the rack. The rack holes should match the rail pins. Extend the rail front and back to fit into the rack.
- Insert the screw in the front and in the back of the rail, as shown in the template. Do not over-tighten the screws.
- Repeat for the right rail.