Veritas NetBackup™ for Informix Administrator's Guide
- Introduction to NetBackup for Informix
- Installing NetBackup for Informix
- Configuring NetBackup for Informix
- About configuring NetBackup for Informix
- About configuring a backup policy for Informix
- Adding a new NetBackup for Informix policy
- About policy attributes
- Configuring an application backup schedule
- Configuring automatic backup schedules
- About schedule properties
- Adding clients to a policy
- Adding NetBackup for Informix scripts to the backup selections list
- Rules for NetBackup for Informix scripts
- Configuring a Standard policy for backup of the $INFORMIXDIR/etc files
- About NetBackup for Informix scripts
- Configuring an additional bp.conf file
- About permissions for NetBackup for Informix log files
- Reviewing the auto-discovered mappings in Host Management
- Configuring the Maximum jobs per client
- Performing a manual backup
- Performing backups and restores of Informix
- About using NetBackup for Informix
- About Informix ON-Bar backup types
- Example Informix backup strategy
- Automatic backup policy for Informix
- Manual backup policy for Informix
- Using the onbar command to perform a user-directed backup
- About browsing Informix backups
- Restoring files to the original client
- Redirecting an Informix restore to a different client
- Example restore of an Informix database
- Troubleshooting
- Verifying the NetBackup for Informix configuration
- Verifying NetBackup for Informix log files
- Enabling the debug logs manually
- About the NetBackup for Informix log files
- About NetBackup server reports
- Setting the debug level
- Minimizing timeout failures on large database restores
- Minimizing the loading and unloading of tapes for database backups
- Deleting expired backups from the Informix backup database
- Delays in completion of backup jobs
- Appendix A. Register authorized locations
Configuring the Maximum jobs per client
The following procedure shows how to set the attribute.
To configure the maximum jobs per client
- In the left pane of the NetBackup Administration Console, expand NetBackup Management > Host Properties.
- Select Master Server.
- In the right pane, double-click the server icon.
- Click Global Attributes.
- Change the Maximum jobs per client value to 99.
The Maximum jobs per client specifies the maximum number of concurrent backups that are allowed per client. The default is 1.
You can use the following formula to calculate a smaller value for the Maximum jobs per client setting:
Maximum jobs per client = number_of_streams X number_of_policies
Refer to the following definitions:
number_of_streams | The number of backup streams between the database server and NetBackup. Each separate stream starts a new backup job on the client. |
number_of_policies | The number of policies of any type that can back up this client at the same time. This number can be greater than one. For example, a client can be in two policies to back up two different databases. These backup windows can overlap. |
Note:
Enter a large enough value for the attribute to meet the number of jobs that Informix runs. You may need to experiment with different values at your site.