Please enter search query.
Search <book_title>...
Veritas NetBackup™ for SAP Administrator's Guide
Last Published:
2018-02-16
Product(s):
NetBackup (8.1.1, 8.1)
- Introduction to NetBackup for SAP
- Introduction to NetBackup SAP HANA
- Installing NetBackup for SAP
- Installing NetBackup for SAP HANA
- Configuring NetBackup for SAP
- About configuring a backup policy for an SAP database
- NetBackup for SAP backup scripts
- About SAP configuration files
- Configuring NetBackup for SAP HANA
- Performing backups and restores of SAP
- Using BRTools to start an SAP backup (for Oracle database only)
- Performing an SAP archive
- Restarting failed NetBackup for SAP backups and restores
- Performing backups and restores of SAP HANA
- NetBackup for SAP with Snapshot Client
- How the NetBackup for SAP Snapshot Client works
- About configuring Snapshot Client with NetBackup for SAP
- About configuring NetBackup for SAP block-level incremental backups on UNIX
- Configuring policies for BLI backups with NetBackup for SAP
- About NetBackup for SAP restores of volumes and file systems using snapshot rollback
- NetBackup for SAP on MaxDB databases
- Troubleshooting NetBackup for SAP and SAP HANA
- NetBackup debug logs and reports
- sapdba logs and messages (Oracle-based SAP environments only)
- About troubleshooting NetBackup for SAP HANA
- Appendix A. backint command line interface
- Appendix B. Input and output files for SAP HANA
- Appendix C. backint -i in_file contents
- Appendix D. backint -o out_file contents
- Appendix E. NetBackup for SAP environment variables for backint
- Appendix F. NetBackup for SAP configuration or bp.conf file settings
- Appendix G. Parameters used in initSID.utl
- sort_backup_type <value>
- sort_restore_type <value>
- Appendix H. Configuring split mirror backups
- Appendix I. Register authorized locations
Setting the debug level on a UNIX client
To control the amount of information that is written to the debug logs, change the "Database" debug level. Typically, the default value of 0 is sufficient. However, Technical Support may ask you to set the value higher to analyze a problem.
The debug logs are located in /usr/openv/netbackup/logs
.
To set the debug level on a UNIX client
- Enter the following line in the bp.conf file.
VERBOSE = X
Where X is the debug level you want.