Veritas NetBackup™ LiveUpdate Guide
- Introduction
- Setting up a LiveUpdate server
- Updating servers and clients
- About LiveUpdate policies
- Creating a LiveUpdate policy
- Importing clients into LiveUpdate policies
- About updating servers
- Stopping NetBackup processes and services before upgrading locally
- Updating servers by using NetBackup LiveUpdate
- Updating clients by using NetBackup LiveUpdate
- About LiveUpdate logs
- Disabling LiveUpdate on NetBackup hosts
- Appendix A. Reference
About LiveUpdate logs
This section describes how to enable and use LiveUpdate logging on Windows and UNIX NetBackup systems.
The following describes the NetBackup LiveUpdate log directories:
|
|
| This log contains information about the LiveUpdate agent. For convenience, the log is copied from the system location and into the NetBackup logging directory. |
| This log contains information about the NetBackup Release Update Installer. For convenience, the log is copied into the NetBackup logging directory. |
On all NetBackup servers and clients, the nbliveup log directory is created when you install NetBackup LiveUpdate.
To enable the liveupdate and the patch logging features, you must first run the appropriate command or create the appropriate directories. These features must be enabled before you run any LiveUpdate policies.
The following describes the different methods you can use to enable these features:
Run the following command on servers and clients: |
|
Create the following directories on servers and clients: |
|
If you do not create these directories, you can only view the additional LiveUpdate logs from their original locations as follows:
|
|
|
|