Veritas Data Insight Administrator's Guide

To configure audit settings on Isilon using OneFS console

1. On the OneFS WebUI, navigate to the CLUSTER MANAGEMENT > Auditing.
2. Under the Edit Auditing Settings section, select Enable Protocol Access Auditing.

   Note:

   It is recommended that you enable the OneFS auditing feature only after you install and configure Data Insight for your storage environment. Otherwise, the backlog consumed by Data Insight may be so large that results may be stale for a prolonged time.

3. Under the Audited Zones section, add the access zone that you want to audit. To enable auditing for the entire Isilon cluster, you can select the default System zone. For more information about access zones, see the EMC Isilon documentation.

   Note:

   Do not enable auditing for the access zones having file systems configured only for the NFS protocol. Data Insight currently does not support monitoring of NFS shares.

4. Under the Event Forwarding section, enter the uniform resource identifier for the server where the Common Event Enabler is installed. The format of the entry is: http://<IP of the CEE server>:port/cee.

   For example: http://10.209.302.152:12228/cee.

   Note that 12228 is the default CEE HTTP listen port. You must choose a port number that is same as the one configured in the registry on the computer where CEE is installed.

   See Preparing Veritas Data Insight to receive event notifications from an EMC Isilon or Unity VSA cluster.

5. Under the section, Event Forwarding, add the host name of the storage cluster. You can either use the EMC Isilon SmartConnect cluster name or the DNS resolvable host name of one of the nodes of the cluster. Do not leave this field blank. This host name is later used to add the EMC Isilon cluster to the Veritas Data Insight configuration.