Veritas™ Resiliency Platform 2.2 Deployment Guide
- Section I. Overview and planning
- Overview of Resiliency Platform
- Recovery to premises using third-party replication technologies
- Recovery to premises using Resiliency Platform Data Mover
- Recovery to AWS using Resiliency Platform Data Mover
- Recovery to vCloud Using Resiliency Platform Data Mover
- System requirements
- Section II. Deploying and configuring the virtual appliances
- Section III. Setting up and managing the resiliency domain
- Setting up the resiliency domain
- Managing Infrastructure Management Servers
- Managing NetBackup and NetBackup Appliances
- Adding NetBackup master server
- Managing Veritas InfoScale Operations Manager Server
- Managing Resiliency Platform Data Mover gateway pairing
- Setting up the resiliency domain
- Section IV. Adding the asset infrastructure
- Managing asset infrastructure
- Preparing and maintaining host assets
- Managing Hyper-V virtualization server assets
- Managing VMware virtualization server assets
- About adding a host for discovery of VMware servers
- Managing enclosure assets
- About the discovery host for enclosures
- Configuration prerequisites for adding storage enclosures to an IMS
- Adding storage enclosures
- Adding RecoverPoint appliance for replication
- Managing asset infrastructure
- Section V. Managing users and global product settings
- Managing licenses
- Managing user authentication and permissions
- Configuring authentication domains
- Managing service objectives
- Managing reports
- Managing settings
- Section VI. Updating or uninstalling the product
- Updating Resiliency Platform
- Using YUM virtual appliance as YUM server
- Uninstalling Resiliency Platform
- Updating Resiliency Platform
- Section VII. Troubleshooting and maintenance
- Troubleshooting and maintenance
- Displaying risk information
- Troubleshooting and maintenance
- Section VIII. Reference
Setting up the resiliency domain
The following tasks are required to set up the infrastructure and basic settings of the Veritas Resiliency Platform resiliency domain. These tasks are performed after you configure the Resiliency Manager and log in to the web console.
Table: Tasks for setting up the resiliency domain
Task | More information |
---|---|
Set up the Resiliency Manager and create the resiliency domain | When you first log in to the console after deploying the Resiliency Manager virtual appliance, the Getting Started wizard requires you to set up the Resiliency Manager and create the resiliency domain. Other steps on the Getting Started wizard are optional and can also be done from the console Settings page after you complete the Getting Started wizard. |
Add Infrastructure Management Servers (IMS) | If you did not add the IMSs using the Getting Started wizard, you can add them later. See Adding an IMS . |
Add the asset infrastructure to the IMS | |
Set up user authentication and personas | |
Configure settings for notifications and other general product settings | See Managing settings for alerts and notifications and miscellaneous product settings. |