NetBackup™ Bare Metal Restore 管理指南

To restore a HP-UX IA client with media boot

1. Prepare to restore the client using the SRT you created on the bootable media.

2. Insert the bootable CD or bootable DVD into the CD-ROM drive.
3. Boot the client to restore.
   
4. In response to the Run a Recovery Shell prompt, type Yes.
5. In response to the Start Networking prompt, type Yes.
6. In response to the Choose the Network Interface prompt, type the default LAN device to boot from.

   You must enter the default LAN because the firmware uses this address for booting from the Ignite server. Note that any network interface card can be used for accessing the SRT or backups, but the default LAN must be used for booting.

7. Enter the following information when prompted:

   • Hostname

   • IP address

   • Default gateway

   • Subnet mask

8. At the Is this network information temporary prompt, type No.
9. Use the arrow key to scroll to OK and press Enter.

10. Enter the required information at the following BMR process prompts:

    • Client name (for a discovery boot, enter the client’s name as it appears in the Tasks view from the prepare-to-discover operation)

    • NetBackup master server name

    • NetBackup master server IP address

    • NetBackup master server gateway IP address

    Due to the automatic recovery parameter set during prepare to restore, the restore operation attempts to retrieve the host-ID based certificate and validate the Certificate Authority (CA) certificate. This recovery is time bound. For more information about the automatic recovery during prepare to restore, 请参见Preparing a client for restore。

    The restore begins.

    注意:

    If you abort the restore operation or if the restore operation fails, either run the prepare to restore operation again to restart the automatic recovery or manually set the Security > Host mappings > Hosts > Menu button > Allow auto reissue certificate option using the NetBackup web UI or command-line interface.

    For more information about manually setting the Allow Auto Reissue Certificate option, see Allowing automatic reissue of a certificate section within the NetBackup Security and Encryption Guide

    https://support.cohesity.com/s/article/article-100040135

    After a successful completion of restore, the host ID-based certificate is copied on the client that is restored. The automatic recovery parameter is reset. For more information about the automatic recovery, 请参见Preparing a client for restore。