Veritas NetBackup™ for NDMP Administrator's Guide
- Introduction to NetBackup for NDMP
- About NetBackup for NDMP
- Types of NDMP backup
- About assigning tape drives to different hosts
- Installation Notes for NetBackup for NDMP
- Configuring NDMP backup to NDMP-attached devices
- About Media and Device Management configuration
- About creating an NDMP policy
- Backup selection options for an NDMP policy
- About enabling or disabling DAR
- Configuring NDMP backup to NetBackup media servers (remote NDMP)
- Configuring NDMP DirectCopy
- Accelerator for NDMP
- Remote NDMP and disk devices
- Using the Shared Storage Option (SSO)
- Backup and restore procedures
- Troubleshooting
- Using NetBackup for NDMP scripts
Viewing NetBackup for NDMP logs
The following procedure describes how to view NetBackup logs.
Note:
The legacy and unified logging files can consume a lot of disk space. Delete the log files when you are finished and set logging to a lower level of detail.
- In the NetBackup Administration Console in the left pane, expand Host Properties > Media Servers, and right-click on the server name in the right pane.
- From the pop-up, select Properties, then click Logging and set the Global logging level to 5.
This increases logging detail to the highest level, for both unified logging and legacy logging.
Note:
NDMP backup performance may in some cases be adversely affected when the logging level is set to 4 or 5. The performance effect may be serious enough to cause NDMP backup failures. Reduce the logging level to 3 or less if you encounter NDMP performance issues or backup failures.
- Click Apply and then OK.
- View the unified logging information in /usr/openv/logs (UNIX) or install_path\logs (Windows) for the following processes:
ndmpagent (originator ID 134)
ndmp (originator ID 151)
nbpem (originator ID 116)
nbjm (originator ID 117)
nbrb (originator ID 118)
- For ndmpagent logs, try the vxlogview command as follows:
/usr/openv/netbackup/bin/vxlogview -I ndmpagent -d T,s,x,p
- For ndmp logs, try the vxlogview command as follows:
/usr/openv/netbackup/bin/vxlogview -I ndmp -d T,s,x,p
- On the NetBackup for NDMP server, create bptm, bpbrm, and ndmpagent legacy debug log folders in the /usr/openv/netbackup/logs directory (UNIX) or install_path\NetBackup\logs folder (Windows):
bpbrm
bpfis
bpmount
bptm
bppfi
ndmpagent
NetBackup writes legacy log files in these directories, if the directories exist.
More Information