Please enter search query.
Search <book_title>...
Veritas NetBackup™ for NDMP Administrator's Guide
Last Published:
2017-09-25
Product(s):
NetBackup (8.1)
- Introduction to NetBackup for NDMP
- About NetBackup for NDMP
- Types of NDMP backup
- About assigning tape drives to different hosts
- Installation Notes for NetBackup for NDMP
- Configuring NDMP backup to NDMP-attached devices
- About Media and Device Management configuration
- About creating an NDMP policy
- Backup selection options for an NDMP policy
- About enabling or disabling DAR
- Configuring NDMP backup to NetBackup media servers (remote NDMP)
- Configuring NDMP DirectCopy
- Accelerator for NDMP
- Remote NDMP and disk devices
- Using the Shared Storage Option (SSO)
- Backup and restore procedures
- Troubleshooting
- Using NetBackup for NDMP scripts
TL8 robot test example for Windows
To exercise the TL8 robot c2t3l0 that the NDMP host stripes controls, use the following test and commands on Windows:
Note:
The drive must be down before you perform this test, or avrd may interfere.
install_path\Volmgr\bin\tl8test -r stripes:c2t3l0 -d1 stripes:/dev/RMT/0cbn
At the prompt, enter ? for help information.
inquiry (Displays the vendor ID and product ID. If you get a UNIT ATTENTION message, try the mode command and then continue your testing.)
s s (Checks slot status.)
s d (Checks drive status.)
m s3 d1 (Moves a tape from slot 3 to drive 1.)
m d1 s3 (Moves the tape back to slot 3.)