Please enter search query.
Search <book_title>...
Veritas NetBackup™ for NDMP Administrator's Guide
Last Published:
2017-09-25
Product(s):
NetBackup (8.1)
- Introduction to NetBackup for NDMP
- About NetBackup for NDMP
- Types of NDMP backup
- About assigning tape drives to different hosts
- Installation Notes for NetBackup for NDMP
- Configuring NDMP backup to NDMP-attached devices
- About Media and Device Management configuration
- About creating an NDMP policy
- Backup selection options for an NDMP policy
- About enabling or disabling DAR
- Configuring NDMP backup to NetBackup media servers (remote NDMP)
- Configuring NDMP DirectCopy
- Accelerator for NDMP
- Remote NDMP and disk devices
- Using the Shared Storage Option (SSO)
- Backup and restore procedures
- Troubleshooting
- Using NetBackup for NDMP scripts
TLD robot test example for UNIX
To exercise drive 1 in the TLD robot c2t3l0 the NDMP host stripes controls, use the following commands on UNIX:
/usr/openv/volmgr/bin/tldtest -r stripes:c2t3l0 -d1 stripes:/dev/RMT/Ocbn
At the prompt, enter ? for help information.
inquiry (Displays the Vendor ID and Product ID. If you get a UNIT ATTENTION message, try the mode command and then continue your testing.)
s s (Checks slot status.)
s d (Checks drive status.)
m s3 d1 (Moves a tape from slot 3 to drive 1.)
unload d1 (Unloads the tape.)
m d1 s3 (Moves the tape back to slot 3.)