Veritas NetBackup™ Administrator's Guide, Volume II
- NetBackup licensing models and the nbdeployutil utility
- How capacity licensing works
- Creating and viewing the licensing report
- Reviewing a capacity licensing report
- Reconciling the capacity licensing report results
- Reviewing a traditional licensing report
- Reviewing an NEVC licensing report
- Additional configuration
- About dynamic host name and IP addressing
- About busy file processing on UNIX clients
- About the Shared Storage Option
- About configuring the Shared Storage Option in NetBackup
- Viewing SSO summary reports
- About the vm.conf configuration file
- Holds Management
- Menu user interfaces on UNIX
- About the tpconfig device configuration utility
- About the NetBackup Disk Configuration Utility
- Reference topics
- Host name rules
- About reading backup images with nbtar or tar32.exe
- Factors that affect backup time
- NetBackup notify scripts
- Media and device management best practices
- About TapeAlert
- About tape drive cleaning
- How NetBackup reserves drives
- About SCSI persistent reserve
- About the SPC-2 SCSI reserve process
- About checking for data loss
- About checking for tape and driver configuration errors
- How NetBackup selects media
- About selecting media in robots
- About selecting media in standalone drives
- About Tape I/O commands on UNIX
About the tpconfig utility menu
Device Management Configuration Utility 1) Drive Configuration 2) Robot Configuration 3) Credentials Configuration 4) Print Configuration 5) Help 6) Quit Enter option:
Table: tpconfig main menu selections describes the main menu selections.
Table: tpconfig main menu selections
Opens a menu to add, delete, or update drive definitions; list definitions of drives and robots; or configure drive paths.
Opens a menu to add, delete, or update robot definitions or list definitions of drives and robots
Opens a menu to add, delete, update, or list credentials for the following:
The List Configuration commands on subsequent menus let you display the current configuration on the screen or write it to a file.
If you specify the -d option only on the tpconfig command, tpconfig writes the current configuration to stdout (the screen) without invoking the menus.
Other command options are available. Run tpconfig -help.
See the NetBackup Commands Reference Guide, available at the following URL:
Terminates the utility and returns you to the UNIX prompt.
You can return to the main menu from anywhere in the utility by entering Ctrl C or by using the Escape key.