Veritas NetBackup™ Device Configuration Guide
- Introducing device configuration
- Section I. Operating systems
- About the required Linux SCSI drivers
- About configuring robot and drive control for Linux
- Installing/reinstalling the sg and the st drivers
- About Solaris robotic controls
- About Solaris tape drive device files
- Configuring Solaris SAN clients to recognize FT media servers
- Section II. Robotic storage devices
- Robot overview
- Oracle StorageTek ACSLS robots
- About removing tapes from ACS robots
- Robot inventory operations on ACS robots
- NetBackup robotic control, communication, and logging
- NetBackup robotic control, communication, and logging for UNIX systems
- ACS robotic test utility
- ACS configurations supported
- Device configuration examples
Attaching devices to a Windows system
The following procedure describes a general method for attaching devices to a Windows computer. The Microsoft Windows device applications available on the server that you use in these steps may differ depending on your Windows operating system.
To attach devices to a Windows system
- Use the appropriate Windows application to obtain information on any currently attached SCSI devices.
- If you attach a new robotic library or drive to a NetBackup media server, follow the vendor's instructions for attaching the device.
Shut down the server and physically attach the supported device. Ensure that SCSI targets and termination settings are consistent with adapter card and peripheral vendor recommendations.
- Reboot the server and answer the prompts for adapter card peripheral configuration options. Watch the display to ensure that the adapter card recognizes the attached peripherals.
- If you add drives, install the tape drivers and use the appropriate Windows application to verify that the drive was recognized.