Veritas NetBackup™ Flex Scale Best Practices and Troubleshooting Guide

Last Published:
Product(s): Appliances (3.1)
Platform: NetBackup Flex Scale OS
  1. Introduction
    1.  
      Scope and intended audience
    2.  
      About NetBackup Flex Scale
    3.  
      About NetBackup Flex Scale nodes
  2. Configuration requirements
    1.  
      Physical environment
    2.  
      NetBackup Flex Scale configuration requirements
    3.  
      Firewall and network ports requirements
    4.  
      Considerations for using IPv6 addresses
  3. Best practices
    1.  
      Management network connectivity
    2.  
      Private network connectivity
    3.  
      Configuring AutoSupport for the appliance
    4.  
      Necessary software
  4. NetBackup Flex Scale tuning and sizing
    1.  
      Assigning media servers to a storage server
    2.  
      NetBackup Flex Scale tuning
  5. Troubleshooting NetBackup Flex Scale
    1.  
      NetBackup Flex Scale logs
    2.  
      Services management
    3.  
      Audit logs
    4. Collecting logs for cluster nodes
      1.  
        Uploading logs to Veritas Support
      2.  
        Downloading logs
    5.  
      Error messages displayed during the pre-upgrade check
    6. Troubleshooting NetBackup Flex Scale issues
      1.  
        If cluster configuration fails (for example because an IP address that was already in use is specified) and you try to reconfigure the cluster, the UI displays an error but the configuration process continues to run
      2.  
        Validation error while adding VMware credentials to NetBackup
      3.  
        NetBackup Web UI incorrectly displays some NetBackup Flex Scale processes as failed
      4.  
        Unable to create BMR Shared Resource Tree (SRT) on NetBackup Flex Scale Appliance
      5.  
        NetBackup configuration files are not persistent across operations that require restarting the system
      6.  
        Connection timeout errors during patch installs, upgrades, and rollback operations
      7.  
        Initial configuration wizard displays a driver node not selected error
      8.  
        Initial configuration wizard displays a license error after successfully configuring the cluster

Initial configuration wizard displays a license error after successfully configuring the cluster

You can add a NetBackup Flex Scale storage license or a NetBackup license while configuring the cluster. The initial configuration wizard displays a license page where you can specify the license details. However, entering the licenses during the cluster configuration itself is not mandatory. In case you skip the licensing page, the cluster is automatically configured with an in-built trial license. After the cluster configuration is successful, the wizard displays the following message:

No valid storage license is provided. A valid license is required to maintain a working cluster. Please add storage licenses after cluster configuration from appliance web GUI.

Cause

While this error message is harmless and does not affect the cluster, it is displayed as a reminder that you must add a valid license in order to maintain a working cluster configuration.

Solution

You can use the NetBackup Flex Scale infrastructure management UI to add a license. Veritas recommends that you add proper licenses before you start protecting production workloads with your appliance.