Veritas NetBackup™ Flex Scale Administrator's Guide
- Product overview
- Viewing information about the NetBackup Flex Scale cluster environment
- NetBackup Flex Scale infrastructure management
- User management
- About Universal Shares
- Node and disk management
- License management
- User management
- NetBackup Flex Scale network management
- Bonding operations
- Data network configurations
- NetBackup Flex Scale infrastructure monitoring
- Resiliency in NetBackup Flex Scale
- EMS server configuration
- Site-based disaster recovery in NetBackup Flex Scale
- Performing disaster recovery using RESTful APIs
- NetBackup Flex Scale security
- Troubleshooting
- Collecting logs for cluster nodes
- Troubleshooting NetBackup Flex Scale issues
- Appendix A. Configuring NetBackup optimized duplication
- Appendix B. Disaster recovery terminologies
- Appendix C. Configuring Auto Image Replication
Monitoring hardware components
After you configure the cluster, you can monitor the hardware components using the NetBackup Flex Scale UI or the Appliance Shell Menu. If a problem is detected, the following notification mechanisms can be used to view and report the issue:
View alerts on the Dashboard or the option of the web interface.
Send email alerts.
Send SNMP alerts.
Share hardware monitoring information for analysis and troubleshooting with Veritas Support using Call Home.
The Hardware tab on the page shows the status of the hardware components for each of the nodes. If a problem occurs and Call Home is enabled, the diagnostic data is automatically sent to Veritas Support and a support case is automatically created. This option helps to provide proactive service and leads to a faster resolution of any hardware issues.
You can monitor the following hardware components in the web interface:
CPU
Fan
Hard disk
Network card
PCI
Power supply
RAID
If a hardware component fails or reports an error, an alert icon is displayed next to the component and the node it belongs to.
You can also use the Veritas Appliance shell menu to check the health and status of the hardware components. After logging in to the shell menu, you can use the following commands to monitor the status:
Command | Description |
---|---|
show hardware-errors | View hardware component faults and errors |
show hardware-health node [component=] | View the status of a specific hardware component. The Item parameter specifies the component for which the data is queried. The following options are available. The default option is All. Note: Some of the options might vary based on the hardware platform.
|