Veritas NetBackup™ Flex Scale Administrator's Guide
- Product overview
- Viewing information about the NetBackup Flex Scale cluster environment
- NetBackup Flex Scale infrastructure management
- User management
- About Universal Shares
- Node and disk management
- License management
- User management
- NetBackup Flex Scale network management
- Bonding operations
- Data network configurations
- NetBackup Flex Scale infrastructure monitoring
- Resiliency in NetBackup Flex Scale
- EMS server configuration
- Site-based disaster recovery in NetBackup Flex Scale
- Performing disaster recovery using RESTful APIs
- NetBackup Flex Scale security
- Troubleshooting
- Collecting logs for cluster nodes
- Troubleshooting NetBackup Flex Scale issues
- Appendix A. Configuring NetBackup optimized duplication
- Appendix B. Disaster recovery terminologies
- Appendix C. Configuring Auto Image Replication
Adding a data network
You can add a new data network.
To add a new data network
- Navigate to Settings > Network > Data Network.
- Click on the Actions button (vertical ellipsis) on the right side of Data-Network. Select Add Data Network.
- The Add data network form appears. Provide the necessary details.
You can choose to have IPv4 or IPv6 addresses in your data network. But mixed mode of IPv4 and IPv6 configuration is not supported.
Note:
You can configure the data network with the IP protocol version used for the management or the data network during initial cluster configuration. You also have an option to select either automatic or custom mode for the new data network to be created.
The NetBackup primary server, media server and the storage server names can contain a maximum of 64 characters, including the domain name.
Interface
Choose eth5 or eth7.
Routing settings
Enter the subnet mask and gateway for the network.
VLAN ID
Enter the VLAN ID.
Media servers
Enter the FQDN and IP address for each media server as per the input method selected.
Storage servers
Enter the FQDN and IP addresses for each storage server as per the input method selected.
Enter the FQDN and IP address of primary server.
Note:
If you deploy a cluster with only media servers, you do not have to enter these details.
Note:
If the cluster is configured in a non-DNS environment, the Automatic option is disabled and you have to specify the FQDNs and the IP addresses.
- Click Add Data Network. The process for adding the network is initiated.
- View the Recent Activity panel in the top navigation bar for the status of the task. You can monitor the status of the operation by clicking View details on the taskbar.
- Once the data network is added successfully, the newly added data network appears under Data Network.