Veritas NetBackup™ 53xx Appliance Initial Configuration Guide

Last Published:
Product(s): Appliances (4.1)
Platform: NetBackup Appliance OS

Command limitations on appliances that are not configured

Before an appliance can be managed, it must first be configured. The commands that are used for initial configuration are the only valid commands that can be executed on a new appliance, or a factory reset appliance. Commands other than those used for the initial configuration can exhibit unexpected or undesired behavior. To prevent this situation, Veritas recommends that you avoid using any management commands until after the appliance initial configuration has been completed.

For information on valid commands for appliances that are not configured, refer to the following documents:

NetBackup Appliance Initial Configuration Guide

NetBackup Appliance Commands Reference Guide