Veritas NetBackup™ Status Codes Reference Guide
- NetBackup status codes
- NetBackup status codes
- NetBackup KMS status codes
- NetBackup status codes
- Media Manager status codes
- Media Manager status codes
- Media Manager status codes
- Device configuration status codes
- Device configuration status codes
- Device configuration status codes
- Device management status codes
- Device management status codes
- Device management status codes
- Robotic status codes
- Robotic status codes
- Robotic status codes
- Robotic error codes
- Robotic error codes
- Robotic error codes
- Security services status codes
- Security services status codes
- Security services status codes
- NetBackup alert notification status codes
NetBackup status code: 93
Explanation: When you load a volume for a backup or restore, the tape manager (bptm) found a volume that loaded without the expected tape header. This error may mean that volumes in a robot are not in the slots that are indicated in the Media and Device Management volume configuration.
Recommended Action: Do the following, as appropriate:
If the volume is in a robot and the robot supports barcodes, perform a Compare robot contents with volume configuration robot inventory (UNIX). The resulting report shows the media ID that was found and validates its slot number with what is in the volume configuration. Then, either change the physical location in the robot or change the volume configuration to show the correct slot.
robot inventory (on Windows) orIf the volume was mounted on a nonrobotic drive, verify that the correct volume was mounted and assigned.
Click here to view technical notes and other information on the Veritas Technical Support website about this status code.