Veritas NetBackup™ 8.0 for VMware Administrator's Guide
- Introduction
- Required tasks: overview
- Notes and prerequisites
- Configure NetBackup communication with VMware
- Configure NetBackup policies for VMware
- VMware backup options
- Configure a VMware Intelligent Policy
- Reduce the size of backups
- Back up virtual machines
- Use Accelerator to back up virtual machines
- Restore virtual machines
- Restoring the full VMware virtual machine
- Virtual Machine Recovery dialog boxes (restore to original location)
- Virtual Machine Recovery dialogs boxes (restore to alternate location)
- Restoring VMware virtual machine disks
- Restoring individual files
- Browse and search virtual machines for restore
- Restore virtual machines with Instant Recovery
- Use NetBackup for vCloud Director
- Virtual machine recovery dialog boxes for vCloud Director
- Best practices and more information
- Troubleshooting
- Appendix A. NetBackup commands to back up and restore virtual machines
- Using NetBackup commands to create a VMware policy
- Appendix B. Configuring services for NFS on Windows
- About configuring services for NFS on Windows 2012 (NetBackup for VMware)
- About configuring services for NFS on Windows 2008 and 2008 R2 (NetBackup for VMware)
- About configuring Services for Network File System (NFS) on the Windows 2003 R2 SP2 NetBackup media server and NetBackup clients (NetBackup for VMware)
- Appendix C. The Reuse VM selection query results option
- Appendix D. Backup of VMware raw devices (RDM)
- Appendix E. SYMCquiesce utility for Linux virtual machines
Requirements for Instant Recovery for VMware
For virtual machine instant recovery, your environment must meet the following requirements:
The virtual machine to restore must have been backed up from a VMware policy.
The target ESX server for the restore must be at vSphere 5.0 or later.
The restore host can be on Windows or Linux.
For a restore host that is separate from the NetBackup master server or media server: You must add the restore host to the list of servers that can access the master server.
In the NetBackup Administration Console, click Additional Servers tab, click to add the restore host.
, double-click the NetBackup master server, and click . On theSee Allowing other servers or clients to restore virtual machines.
The NFS Client service must be enabled on the ESXi host.
The Services for Network File System (NFS) must be installed on the Windows media server and restore host.
See About configuring services for NFS on Windows 2012 (NetBackup for VMware).
See About configuring services for NFS on Windows 2008 and 2008 R2 (NetBackup for VMware).
The NetBackup media server platform must support Granular Recovery Technology. See the NetBackup Enterprise Server and Server OS Software Compatibility List:
The Client for NFS service may have to be restarted on a NetBackup Windows restore host.
See Restarting the Client for NFS service on a Windows restore host.
The media server must use IPv4 (IPv6 is not supported).
Note: If the media server is registered with IPv6 but is configured for both IPv4 and IPv6, use the following workaround:
On the ESX server, add an entry to the
/etc/hosts
file, to remap the media server host name to its IPv4 address. For example:10.84.65.60 mserver7.acme.com
Where
10.84.65.60
is the IPv4 address of the media servermserver7
.NetBackup requires logon credentials for the vCenter server and the restore host.