NetBackup™ Web UI VMware Administrator's Guide
- Introducing the NetBackup web user interface
- Monitoring NetBackup
- Managing VMware servers
- Add VMware servers
- Validate and update VMware server credentials
- Browse VMware servers
- Remove VMware servers
- Create an intelligent VM group
- Remove an intelligent VM group
- Add a VMware access host
- Remove a VMware access host
- Change resource limits for VMware resource types
- Change the autodiscovery frequency of VMware assets
- Discover VMware server assets manually
- Protecting VMs
- Instant access
- Instant rollback
- Continuous data protection
- CDP terminology
- CDP Architecture
- About continuous data protection
- Prerequisites
- Capacity-based licensing for CDP
- Configuring CDP
- Defining the CDP gateway
- Sizing considerations
- Limiting concurrent CDP backup jobs
- Controlling full sync
- Monitoring CDP jobs
- Using accelerators with CDP
- Recovering CDP protected VMs
- Some limitations of CDP
- Troubleshooting for CDP
- VM recovery
- Troubleshooting VMware operations
- Errors when adding VMware servers
- Errors when browsing VMware servers
- Errors for the Status for a newly discovered VM
- Error when downloading files from an instant access VM
- Troubleshooting backups and restores of excluded virtual disks
- Restore fails for a virtual machine with multiple datastores
- Errors when you change the recovery destination
About restricted restore mode
The restricted restore mode option is a form of VMware agentless restore for restricted environments such as Windows User Account Control (UAC). The user-selected files are first staged to the recovery host and then restored to the virtual machine. The recovery host must have sufficient space for staging.
The default staging location on the recovery host is install_path\VERITAS\NetBackup\var\tmp\staging. NetBackup creates this directory with the correct permissions the first time it is accessed. You can change the staging location with the AGENTLESS_RHOST_STAGING_PATH registry setting on the recovery host. This REG_SZ registry key does not exist by default. It must be created in HKEY_LOCAL_MACHINE\SOFTWARE\VERITAS\NetBackup\CurrentVersion\Config.
If you change the staging location, Veritas recommends that you let NetBackup create the staging directory. When you let NetBackup create the directory, the permissions are set correctly. For NetBackup to create the new staging directory, the immediate parent directory must exist. If you want the restore to use E:\recovery\staging, then E:\recovery must exist. If the E:\recovery directory does not exist, the restore fails.
If you create the directory yourself, the , the domain administrator, and the local administrator accounts must have permissions. Additionally, Access Control Lists inherited from the parent directory are not secure and must be disabled.
Restricted restore mode supports alternate location restores. You can configure the alternate location in the NetBackup web UI.
Limitations of restricted restore mode:
Restricted restore mode is currently only supported on Windows. The recovery host must also be Windows.
The file ownership of the restored files is set to the account that was used for the NetBackup backup operation.
Restore of ACLs is not supported.
Restricted restore mode does not support renaming of targets for soft links.
Restricted restore mode creates new files where hard links had previously been used.
Irregular files such as sparse files, device files, special files, and junction points are not supported.
A supported version of VMware Tools must be running for the restore to succeed.
File path length with the directory cannot exceed 260 characters.
File transport through the required infrastructure for this restore method is significantly slower than VMware agentless restores. As a result of performance concerns, Veritas recommends limiting the restore to fewer than 100 files and less than 1 GB of data.