Veritas InfoScale™ 7.3.1 Installation Guide - Linux
- Section I. Introduction to Veritas InfoScale
- Section II. Planning and preparation
- System requirements
- Preparing to install
- Setting up the private network
- Setting up shared storage
- Planning the installation setup for SF Oracle RAC and SF Sybase CE systems
- Section III. Installation of Veritas InfoScale
- Installing Veritas InfoScale using the installer
- Installing Veritas InfoScale using response files
- Installing Veritas Infoscale using operating system-specific methods
- Completing the post installation tasks
- Section IV. Uninstallation of Veritas InfoScale
- Uninstalling Veritas InfoScale using the installer
- Uninstalling Veritas InfoScale using response files
- Section V. Installation reference
- Appendix A. Installation scripts
- Appendix B. Tunable files for installation
- Appendix C. Troubleshooting installation issues
SF Oracle RAC and SF Sybase CE hardware requirements
Table: Hardware requirements for basic clusters lists the hardware requirements for basic clusters.
Table: Hardware requirements for basic clusters
Item | Description |
---|---|
DVD drive | A DVD drive on one of the nodes in the cluster. |
Disks |
All shared storage disks support SCSI-3 Persistent Reservations (PR). Note: The coordinator disk does not store data, so configure the disk as the smallest possible LUN on a disk array to avoid wasting space. The minimum size required for a coordinator disk is 128 MB. |
RAM | Each system requires at least 2 GB. |
Swap space | For SF Oracle RAC: See the Oracle Metalink document: 169706.1 |
Network | Two or more private links and one public link. Links must be 100BaseT or gigabit Ethernet directly linking each node to the other node to form a private network that handles direct inter-system communication. These links must be of the same type; you cannot mix 100BaseT and gigabit. Veritas recommends gigabit Ethernet using enterprise-class switches for the private links. Oracle RAC requires that all nodes use the IP addresses from the same subnet. |
Fiber Channel or SCSI host bus adapters | At least one additional SCSI or Fibre Channel Host Bus Adapter per system for shared data disks. |