Veritas NetBackup™ for Nutanix Acropolis Hypervisor (AHV) Administrator's Guide
- Introduction to NetBackup for Acropolis Hypervisor (AHV)
- Prerequisites and things to consider before using Nutanix for AHV
- Configuring NetBackup communication with AHV
- Establishing communication between NetBackup and Nutanix AHV
- Configuring secure communication between the Nutanix Acropolis Hypervisor server and NetBackup host
- Adding the Nutanix Acropolis Hypervisor Cluster credentials for NetBackup
- Adding a backup host to the NetBackup master server
- Adding a backup host to the Acropolis Cluster access list
- Configuring NetBackup policies for AHV
- Backup and recovery
- Back up the Nutanix AHV virtual machines
- Overview of the Nutanix AHV virtual machines recovery process
- About recovering the Nutanix AHV virtual machines
- Planning the recovery of a Nutanix AHV VM
- Recovering a Nutanix AHV VM using the Backup, Archive, and Restore console
- About recovering AHV VMs from the images that are backed up using NetBackup versions 8.1, 8.1.1, or 8.1.2
- Recovering a Nutanix AHV VM using the command line for Hypervisor policy
- Troubleshooting issues
- Appendix A. NetBackup commands to backup and restore Nutanix AHV virtual machines
- Index
Prerequisites
The following prerequisites apply to NetBackup for AHV.
For the required NetBackup licenses, see the following page:
How to use NetBackup plug-ins and agents: download, install, and availability information
For information on supported versions and support for Nutanix AHV, see Support for NetBackup in a Virtual Environment list from the NetBackup Master Compatibility List page.
If you want to restore a VM to another Nutanix AHV cluster, ensure that the AHV cluster has the same configuration as the original AHV cluster.
Verify that the following requirements are met for the NetBackup server:
The NetBackup server software is installed and operational on the NetBackup servers.
Ensure that you configure any backup media that the storage unit uses.
The required number of media volumes depend on the following:
The devices that are used and storage capacity of the media
The sizes of the virtual machines that you want to back up
The amount of data that you want to archive
The size of your backups
The length of retention of the backup images
Verify that the NetBackup client software is installed on the backup host.
For detailed information about licenses and adding licenses, refer to the following:
How to use NetBackup plug-ins and agents: download, install, and availability information
"Adding NetBackup licenses" section of the NetBackup Administrator's Guide, Volume I.