Veritas NetBackup™ Appliance Fibre Channel Guide
- About NetBackup Fibre Transport and SAN Client
- About optimized duplication and Auto Image Replication over FC
- About backup to tape support
- VMware support
- Supported Fibre Channel features on NetBackup appliances
- NetBackup Appliance rear panel configurations
- About the HBA port mode configuration
- Zoning the FC SAN
- About the Fibre Transport page on the NetBackup Appliance Web Console
- Configuring Fibre Transport on the appliance
- How to configure Fibre Transport media server for SAN Client
- How to configure Fibre Transport for optimized duplication and Auto Image Replication over FC
- Configuring Fibre Transport to other NetBackup appliances
About Fibre Transport media server verification
After you install and configure a Fibre Transport (FT) media server, you can use the Settings > FibreTransport SANClient Show command to show the status of the SAN Client feature. When you run the FibreTransport SANClient Show command and the Fibre Transport (FT) media server is configured properly, you see an output similar to the following:
Testsys.Settings> FibreTransport SANClient Show Fibre Transport server installed and running.
You can also use the Manage > FC Show command to verify and confirm the status of the SAN Client feature. From the output that you receive after you have run the Manage > FC Show command, you can verify the following:
The qla2xxx and windrvr6 drivers are loaded.
The target ports are in Target mode by physical state, and their configuration type is Target(FTMS)
Under the Status column, the target mode ports should have a status of if the port is physically connected to something such as a switch
Nothing ever appears under the Remote Ports column for target mode ports.
To find more information about the target mode ports, you must look at the VxUL logs for the originator 199 (nbftsvr).