NetBackup™ Network Ports Reference Guide
- About the NetBackup network ports
- NetBackup Ports
- NetBackup default ports
- NetBackup master server ports
- NetBackup media server ports
- NetBackup client ports
- Web UI ports
- Java Console ports
- NDMP server ports
- DataDomain OpenStorage ports
- NetBackup Granular Restore Technology (GRT) ports
- Network and port address translation
- Configuring ports for the NetBackup legacy Web Services
- Other Network Ports
- NetBackup deduplication ports
- NetBackup 5200 and 5220 appliance ports (for firewall between master and media server)
- NetBackup VMware ports
- Port usage for the NetBackup vSphere Web Client Plug-in
- Nutanix AHV cluster ports
- Port requirements for Kubernetes operator deployment
- NetBackup CloudStore Service Container (nbcssc) port
- Index
TCP ports used by NetBackup
NetBackup primarily uses the TCP protocol to communicate between processes. The processes can run on the same host or on different hosts. This distributed client-server architecture requires that the destination TCP ports specific to the NetBackup processes be open through any firewalls within the networking infrastructure.
Firewalls may also be configured to filter connections based on the source port. NetBackup typically uses non-reserved source ports for outbound connections.
The sections that follow describe the TCP ports used by NetBackup in the default configuration. The network layers on the hosts and the networking devices between the hosts must be configured to allow these connections. NetBackup requires the proper connections to be configured or it cannot operate.