Search <book_title>...

InfoScale™ 9.0 Cluster Server Agent for Sybase Installation and Configuration Guide - Solaris

Last Published: 2025-04-14

Product(s): InfoScale & Storage Foundation (9.0)

Platform: Solaris

Enabling and disabling intelligent resource monitoring (IMF) for agents

Review the following procedures to enable or disable intelligent resource monitoring manually. The intelligent resource monitoring feature is enabled by default. The IMF resource type attribute determines whether an IMF-aware agent must perform intelligent resource monitoring.

Note:

VCS provides haimfconfig script to enable and disable IMF for agents. You can use the script when VCS is running or when VCS is stopped. Use the script to enable or disable IMF for the IMF-aware bundled agents, enterprise agents, and custom agents.

For additional information, refer to Enabling and disabling IMF for agents by using script section in Cluster Server Administrator's Guide.

See How the Sybase and SybaseBk agents support intelligent resource monitoring .

Note:

All Sybase resources in the cluster gets modified when you enable or disable IMF monitoring for agents.

To enable intelligent resource monitoring

Make the VCS configuration writable.
```
# haconf -makerw
```
Run the following command to enable intelligent resource monitoring.
- To enable intelligent monitoring of offline resources:
```
# hatype -modify resource_type IMF -update Mode 1
```
- To enable intelligent monitoring of online resources:
```
# hatype -modify resource_type IMF -update Mode 2
```
- To enable intelligent monitoring of both online and offline resources:
```
# hatype -modify resource_type IMF -update Mode 3
```
You can also change the values of the MonitorFreq key and the RegisterRetryLimit key of the IMF attribute.
See Attribute definitions for the Sybase agent.
See Attribute definitions for the SybaseBk agent.
Save the VCS configuration
```
# haconf -dump -makero
```
Make sure that the AMF kernel driver is configured on all nodes in the cluster.
```
# svcs -l amf
```
Configure the AMFdriver if the command output returns that the AMFdriver is not loaded or not configured.
See Administering the AMF kernel driver.

Restart the agent. Run the following commands on each node.

# haagent -stop agent_name -force -sys sys_name
# haagent -start agent_name -sys sys_name

To disable intelligent resource monitoring

Make the VCS configuration writable.
```
# haconf -makerw
```
To disable intelligent resource monitoring for all the resources of a certain type, run the following command:
```
# hatype -modify Sybase IMF -update Mode 0
```
To disable intelligent resource monitoring for a specific resource, run the following command:
```
# hares -override resource_name IMF
# hares -modify resource_name IMF -update Mode 0
```
Save the VCS configuration.
```
# haconf -dump -makero
```

Note:

For Sybase cluster edition, the agent performs a monitoring check based on qrmutil whenever the monitor entry point is executed, either because IMF MonitorFreq is reached or LevelTwoMonitorFreq is reached. For example, if IMF MonitorFreq is set to a higher value such as 10, monitoring check based on qrmutil is performed after 10 x MonitorInterval seconds.