NetBackup Flex Appliance SNMP Traps Reference Guide
- Overview
- SNMP traps
- vrtsapplianceClusterServicesTrap
- vrtsapplianceLocalServicesTrap
- vrtsbbuTrap
- vrtscmosbatteryTrap
- vrtscpuTrap
- vrtsdimmTrap
- vrtsdiskTrap
- vrtsenclosurediskTrap
- vrtsenclosurefanTrap
- vrtsenclosurepowerTrap
- vrtsenclosuretemperatureTrap
- vrtsfanTrap
- vrtsfibrechannelTrap
- vrtsfirmwareTrap
- vrtspowerTrap
- vrtsraidgroupTrap
- vrtsReplicationInstanceTrap
- vrtsReplicationPeerTrap
- vrtsssdTrap
- vrtstemperatureTrap
- vrtsvolumeTrap
vrtsReplicationInstanceTrap
OID: 1.3.6.1.4.1.48328.3.9.2.25
The vrtsReplicationInstanceTrap monitors the status of remote replication between instances. If you receive an alert, it means that the replication has experienced an error or has failed.
Check the value of the <node prefix>_replicationinstance_<replica instance ID>_status field to see the exact error. The ID that displays before _status indicates which instance the issue occurred on.
Based on the information, take one of the following actions:
Table: Next steps for the vrtsReplicationInstanceTrap
Value | What to do now |
|---|---|
If the status is Data lag is high, the replication data lag of the instance is above the warning threshold of the low watermark. | Check to see if replication is paused or the replication network is disconnected. If the issue persists, contact Support for assistance. |
If the status is Data lag is too high, the replication data lag of the instance is above the critical threshold of the high watermark. | Check the bandwidth of the replication network. If the bandwidth is sufficient, contact Technical Support to increase the size of the Storage Replicator Log volume. Otherwise, the Storage Replicator Log may fill, and replication will be interrupted. |
If the status is Recovery point status is behind, the recovery point status of the instance is above the threshold. | Check to see if replication is paused or the replication network is disconnected. If not, consider increasing the bandwidth of the replication network. |
If the status is Instance replication is paused, replication was paused between the active and the replica instance. | The longer that replication is paused, the longer it takes for the data to sync again when you resume. Resume replication as soon as possible. |
If the status is Data status is inconsistent, the data is out of sync between the active and replica instances. | The replica instance will not work until the resynchronization completes and the data status becomes at least crash consistent. Contact Support for assistance. |
If the status is Instance replication is interrupted, instance replication has been interrupted because the Storage Replicator Log is full or unavailable. | Contact Support for assistance. |