Veritas™ 5350 Appliance Product Description Guide
- About the Veritas 5350 Appliance
- About the Veritas 5350 Appliance
- Features and components of the appliance
- Locating the appliance serial number
- Compute node disk drive configurations
- About the compute node front panel USB port
- About the compute node control panel
- About the compute node rear panel
- Appliance network interface card port assignments
- Veritas 5350 Appliance I/O configuration options
- Available PCIe-based I/O configurations
- Total I/O on-board and PCIe ports
- Available I/O configurations by slot for Veritas 5350 Appliance installations
- RSP3GD016J storage adapter
- Mellanox ConnectX-4 Lx EN MCX4121A-ACAT Ethernet card
- QLE2692 dual-port 16Gb Fibre Channel host bus adapter
- Intel Storage Adapter RS3P4GF016J
- Broadcom P225p 10/25Gb PCIe Ethernet card
- About the Veritas 5U84 Storage Shelves
- About Veritas 5350 Appliance storage shelves
- About the 5U84 Primary Storage Shelf and 5U84 Expansion Storage Shelf rear components
- Veritas 5350 Appliance and 5U84 Storage Shelf cables
- Appendix A. Technical specifications, Environmental/Protocol standards, and Compliance standards
- Veritas 5350 compute node technical specifications
- Veritas 5U84 Storage Shelf technical specifications
- Environmental specifications
- Protocol standards
- Regulatory, compliance, and certification information
- Product regulatory compliance
- Country approvals
- Product safety compliance
- Product EMC Compliance - Class A Compliance
- Product environmental compliance
Broadcom P225p 10/25Gb PCIe Ethernet card
The Broadcom® BCM957414A4142CC is a dual-port 25 Gb/s, PCI-Express Gen3 x8 Network Interface Card that supports both SFP28/SFP+ optical modules and copper direct attach cable. The card uses the Broadcom BCM57414 25GbE MAC controller with the integrated dual channel 25GbE SFI transceiver.
By default, a 10 GB SFP is shipped with the appliance.
Note:
Veritas recommends that you use Finisar FTLX8574D3BCV SFP part for 10G connectivity and Mellanox MMA2P00-AS SFP part for 25G connectivity.
Note:
The Broadcom P225p 10/25Gb PCIe Ethernet card does not support the installation of a 10G SFP and 25G SFP within the same card. You must either have SFPs with the same maximum speed on both ports at any given time or remove the unused SFP from the card.
Table: Broadcom P225p NIC adapter specifications
Item | Specification |
|---|---|
Bracket height | Full height |
Power consumption | Typical: 12.5 watts Maximum: 12.9 watts |
Operating temperature | 0°C to 55°C (32 F to 131 F) |
Storage temperature | -40°C to +70°C (-49°F to +221°F) |
Storage humidity | 90% at 35°C |
System interface type | PCIe v3.0 |
Speed and slot width | 8.0 GT/s (gigatransfers per second), 8-Lane |
Data rate supported per port | 10/25Gb |
Air Flow (minimum) | 150 LFM (linear feet per minute) |