Enterprise Vault™ Setting up File System Archiving (FSA)

To configure pass-through recall for a Windows file server

1. Ensure that the FSA Agent is installed on the file server.

   See About installing the FSA Agent on a Windows file server.

2. In the Administration Console, expand the Enterprise Vault site until the Targets container is visible.
3. Expand the Targets container, and then expand the File Servers container
4. Right-click the Windows file server for which you want to configure pass-through recall and then, on the shortcut menu, click Properties.

   The settings for pass-through recall are on the file server properties General tab.

5. Select Configure pass-through recall.
6. Enter a location on the file server for the disk cache that Enterprise Vault uses when it recalls files. We recommend that you specify a location on a high-performance disk. The Vault Service account must have write permission on the folder.
7. Select a disk cache size. Typically there is little benefit in increasing the cache size from its default setting.
8. Click OK to save the changes to the file server's properties.
9. Enable pass-through recall for each existing volume on the file server on which you want to use this feature. Select Enable pass-through recall on the General tab of the volume's properties.

   Note:

   If you add new volumes for archiving on the file server, Enterprise Vault does not enable them for pass-through recall. You must enable new volumes for pass-through recall manually, if required.