NetBackup IT Analytics Data Collector Installation Guide for Replication Manager
- Pre-Installation setup for NetApp (Replication)
- Installing the Data Collector software
- Introduction
- Installing the WMI Proxy service (Windows host resources only)
- Testing WMI connectivity
- Considerations to install Data Collector on non-English systems
- Install Data Collector Software on Windows
- Install Data Collector software on Linux
- Deploy Data Collector in native Kubernetes environment
- Configure Data Collector manually for Veritas NetBackup
- Install Data Collector binaries on Windows (without configuration)
- Install Data Collector binaries on Linux host (without configuration)
- Validating Data Collection
- Uninstalling the Data Collector
- Manually starting the Data Collector
- Appendix A. Firewall configuration: Default ports
Introduction
The installer configures the Data Collector to start automatically, however, it does not actually start it upon completion of the installation because you must first validate the installation. Follow these steps, for the relevant operating system, to manually start the Data Collector service.
This also starts the Aptare Agent process, Zookeeper, and Kafka services on the respective systems.
The installer configures the Data Collector process as a Service.
To view the Data Collector Status:
Click
Click .
Click . The Services dialog is displayed.
Start the Aptare Agent service.
The installer automatically copies the Data Collector "start" and "stop" scripts to the appropriate directory, based on the vendor operating system.
To start the data collector, use the following command:
/opt/aptare/mbs/bin/aptare_agent start