NetBackup™ for SQLite Administrator's Guide
- Introduction to NetBackup for SQLite Agent
- Installing the NetBackup for SQLite Agent
- Planning the installation of NetBackup for SQLite Agent
- Verifying the operating systems and platforms
- Installing prerequisites for NetBackup for SQLite Agent
- Post-installation requirements for NetBackup for SQLite Agent
- Describing the NetBackup for SQLite Agent package
- Installing the NetBackup for SQLite Agent
- Uninstalling the NetBackup for SQLite Agent
- Configuring the NetBackup for SQLite
- NetBackup for SQLite backup and restore
- Troubleshooting for NetBackup for SQLite
- Appendix A. NetBackup for SQLite commands and conventions
- Appendix B. NetBackup for SQLite commands
- Index
About NetBackup for SQLite Agent commands
This section describes the commands, options, and parameters that are available to run the nbsqlite operations. Each command contains a brief description, required parameters, and optional parameters for the respective operations. The agent supports only those commands, options, and parameters that are mentioned in this document.
The nbsqlite.conf file keeps you from providing the parameters every time you run the operations.
Observe for the following:
Set the parameters in the
nbsqlite.conffile or on the nbsqlite command line.The parameters you set on the command line, takes precedence over the
nbsqlite.conffile.Set the operation type (-o) on the nbsqlite command line.
Set the other parameters and options for the respective operation on the nbsqlite command line or in the
nbsqlite.conffile.