Veritas NetBackup™ Status Codes Reference Guide
- NetBackup status codes
- NetBackup status codes
- NetBackup KMS status codes
- NetBackup status codes
- Media Manager status codes
- Media Manager status codes
- Media Manager status codes
- Device configuration status codes
- Device configuration status codes
- Device configuration status codes
- Device management status codes
- Device management status codes
- Device management status codes
- Robotic status codes
- Robotic status codes
- Robotic status codes
- Robotic error codes
- Robotic error codes
- Robotic error codes
- Security services status codes
- Security services status codes
- Security services status codes
- NetBackup alert notification status codes
NetBackup status code: 297
Explanation: This error occurs when a try is made to eject a non-existent or bad media ID during the eject phase of the following: a Vault session, a vlteject command, or a vltopmenu command.
Possible reasons for this error are as follows:
The bad media ID was added by means of the
vlt_ejectlist_notify
script.The bad media ID is already in the MAP or not in the robotic library.
The bad media ID is in a robotic drive.
The bad media ID is in transit in the robotic library.
Recommended Action: Remove or correct the defective media ID from the vlt_ejectlist_notify
script and rerun the Vault session. If the bad media ID is in the MAP or a drive or in transit, something is misconfigured.
Click here to view technical notes and other information on the website about this status code.