NetBackup™ for Sybase Administrator's Guide
- Introduction to NetBackup for Sybase
- Installing NetBackup for Sybase
- Planning the installation of NetBackup for Sybase
- Verifying the operating system and platform compatibility
- NetBackup server and client requirements
- Sybase server software requirements
- Requirements for using NetBackup for SAP MaxDB, SAP Oracle, and SAP HANA in a NetBackup cluster
- About the license for NetBackup for Sybase
- Copying the NetBackup for Sybase library to each Sybase instance
- Running the sybase_config script
- Adding new Sybase instances
- Configuring NetBackup for Sybase
- About NetBackup for Sybase configuration
- About configuring a backup policy for Sybase
- About the backup, restore, and load scripts for NetBackup for Sybase on UNIX
- About the backup, restore, and load scripts for NetBackup for Sybase on Windows
- Modifying the backup script for NetBackup for Sybase on Windows
- sybase_mdb_backup.cmd script
- Additional information for editing the backup script for NetBackup for Sybase on Windows
- Modifying the restore script for NetBackup for Sybase on Windows
- sybase_mydb_restore.cmd script example for NetBackup
- Additional information for editing the restore script for NetBackup for Sybase on Windows
- Modifying the NetBackup for Sybase load script
- NetBackup for Sybase environment variables
- NetBackup for Sybase configuration or bp.conf file settings
- Configuring the logon account for the NetBackup Client Service for NetBackup for Sybase
- About striped dumps and loads with NetBackup for Sybase
- Reviewing the auto-discovered mappings in Host Management
- About permissions for NetBackup for Sybase log files (UNIX)
- Configuring the Maximum jobs per client
- Performing a manual backup
- Using NetBackup for Sybase
- Troubleshooting NetBackup for Sybase
- NetBackup debug logs and reports
- Enabling the debug logs for a NetBackup for Sybase client automatically (Windows)
- Enabling the debug logs manually (UNIX)
- About the bphdb directory on the Windows database client
- About the bphdb directory on the UNIX database client
- About the sybackup directory on the UNIX database client
- About the sybackup directory on the Windows database client
- Setting the debug level on a UNIX client
- About NetBackup server reports
- Sybase Backup Server log and messages
- Minimizing timeout failures on large database restores
- Minimizing the loading and unloading of tapes for database backups
- NetBackup debug logs and reports
- Appendix A. Register authorized locations
Configuring the Maximum jobs per client
The following procedure shows how to set the attribute.
To configure the maximum jobs per client
- In the left pane of the NetBackup Administration Console, expand NetBackup Management > Host Properties.
- Select Master Server.
- In the right pane, double-click the server icon.
- Click Global Attributes.
- Change the Maximum jobs per client value to 99.
The Maximum jobs per client specifies the maximum number of concurrent backups that are allowed per client. The default is 1.
You can use the following formula to calculate a smaller value for the Maximum jobs per client setting:
Maximum jobs per client = number_of_streams X number_of_policies
Refer to the following definitions:
number_of_streams | The number of backup streams between the database server and NetBackup. Each separate stream starts a new backup job on the client. |
number_of_policies | The number of policies of any type that can back up this client at the same time. This number can be greater than one. For example, a client can be in two policies to back up two different databases. These backup windows can overlap. |
Note:
Enter a large enough value for the attribute to meet the number of jobs that Sybase runs. You may need to experiment with different values at your site.