Veritas Access Appliance 8.1 Solutions Guide for Enterprise Vault

Last Published:
Product(s): Appliances (8.1)
Platform: Veritas 3340,Veritas 3350
  1. Introduction
    1.  
      About this document
    2.  
      About Access Appliance as archival storage for Enterprise Vault
    3.  
      Access Appliance versions certified by Enterprise Vault
  2. System Requirements
    1.  
      Server roles
    2.  
      Hardware requirements
    3.  
      Software requirements
  3. Installing and configuring Enterprise Vault with Access Appliance
    1.  
      Enterprise Vault deployment
    2.  
      Access Appliance deployment
  4. Access Appliance features for Enterprise Vault archival storage
    1.  
      Write-Once-Read-Many support
    2.  
      Partition Secure Notification
  5. Access Appliance archival policy configuration for Enterprise Vault
    1.  
      Configuring CIFS for the Active Directory domain mode
    2.  
      Access Appliance GUI policies for archival storage
    3.  
      Configuring the replication job
    4.  
      Configuring the archival policy using GUI
    5.  
      Configuration of CIFS shares for archival using Veritas Access CLISH
    6.  
      Storage provisioning using policies
    7.  
      Configuring Access Appliance storage with Enterprise Vault store partition
    8. Episodic replication job failover and failback
      1.  
        Process summary
      2.  
        Overview of the planned failover process
      3.  
        Overview of the planned failback process
      4.  
        Overview of the unplanned failover process
      5.  
        Overview of the unplanned failback process
    9. Continuous replication failover and failback
      1.  
        Process summary
      2.  
        Overview of the planned failover process
      3.  
        Overview of the planned failback process
      4.  
        Overview of the unplanned failover process
      5.  
        Overview of the unplanned failback process
    10.  
      Configuring replication failover and exporting CIFS share from target cluster
  6. Troubleshooting
    1.  
      Log locations for troubleshooting
    2.  
      Additional resources
  7.  
    Index

Enterprise Vault deployment

Before you install Enterprise Vault, the Enterprise Vault Deployment scanner should be run on each of the intended Enterprise Vault servers.

If you want to configure partitions in both IPv6 and IPv4 modes, the following network settings are required on Enterprise Vault and the Active Directory (AD) server.

Network settings> NIC Properties> Enable IPv6 and Enable IPv4.

For more information, see the Enterprise Vault™ Installing and Configuring Guide on SORT.