NetBackup™ Access 3350 Appliance Product Description
- About the Access 3350 Appliance
- About the Access 3350 Appliance
- Features and components of the appliance
- Locating the appliance serial number
- About 3350 compute node disk drive configurations
- About the compute node front panel USB port
- About the compute node control panel
- About the compute node rear panel
- Standard 3350 Appliance PCIe-based I/O configuration
- About the 5U84 Storage Shelves
- About Access 3350 Appliance storage shelves
- About the 5U84 Primary Storage Shelf and 5U84 Expansion Storage Shelf rear components
- Access 3350 Appliance and 5U84 Storage Shelf cables
- Appendix A. Technical specifications, Environmental/Protocol standards, and Compliance standards
- 3350 Appliance compute node technical specifications
- Veritas 5U84 Storage Shelf technical specifications
- Environmental specifications
- Protocol standards
- Regulatory, compliance, and certification information
- Index
3350 Appliance network interface card port assignments
The following section describes the on-board 1Gb network interface card (NIC) port assignments and the PCIe-based 10/25Gb NIC port assignments for the 3350 Appliance.
Table: Appliance compute node network interface port information
Port | Function |
|---|---|
eth0/NIC1 (copper/RJ45 connector) | Used for management functions of the appliance. You can connect NIC1 (eth0) to an administrative network that does not provide any backup data transfer. |
eth1/NIC2 (copper/RJ45 connector) | A 1-GbE port that can be configured as an administrative network port that does not provide any backup data transfer. |
priveth0 (eth2/NIC3) (copper/RJ45 connector) | A 1-GbE private network port that is used for connections between the two appliance compute nodes |
priveth1 (eth3//NIC4) (copper/RJ45 connector) | A 1-GbE private network port that is used for connections between the two appliance compute nodes. |
IPMI port (copper/RJ45 connector) | A 1-GbE port that is used for appliance remote management purposes. |
pubeth0 (eth4) * | A 10/25GbE port that is used for general network uses. |
pubeth1 (eth5) * | A 10/25GbE port that is used for general network uses. |
pubeth2 (eth6)* | A 10/25GbE port that is used for general network uses. |
pubeth3 (eth7) * | A 10/25GbE port that is used for general network uses. |