1. Support
  2. Knowledge base
  3. 100031237

V-79-57344-33859 - One or more SQL Database consistency checks have failed" appears in the backup job log while backing up Microsoft SQL Server or SQL databases

Article: 100031237
Last Published: 2022-11-08
Ratings: 3 3
Product(s): Backup Exec

Problem

Error "0xe0008443 - One or more SQL Database consistency checks have failed" appears in the backup job log while backing up Microsoft SQL Server or SQL databases.

Error Message

Final error: 0 xe0008443 - One or more SQL Database consistency checks have failed.
Final error category: Resource Errors
For additional information regarding this error refer to link V-79-57344-33859
 
 
The job log also reports the following error:
 
"An unknown or unexpected database error occurred while attempting a DBCC."
 
V-79-65323-3224 - An error occurred on a query to database
UMI Code: V-379-57859 : There was a problem running the DBCC

Cause

SQL has found some inconsistencies with the database/s mentioned in the job log.

Solution

Backup Exec has the ability to check the logical and physical consistency of SQL data before and/or after a backup. SQL reports any consistency check failures in the Backup Exec job log. Veritas recommends running consistency checks either before or after SQL backups.
 
Backup Exec's backup job definition uses a 'Physical_Only' SQL consistency check before backup by default. Full checks with/without indexes are also options.  Additionally, by default a backup job will continue even if the DBCC fails.  Confirm this setting in the job definition per Figure 1 below.

 

The consistency check that is run is actually a part of the SQL program and Backup Exec merely triggers the consistency check. If errors are reported, try running the DBCCs manually through SQL.
 
 
How  to check the Database consistency in SQL:
 
1. Open SQL Management Studio and connect to the SQL instance
2. Click on "New Query".
3. Type the following commands and click on "Execute"
 
use DatabaseName
dbcc checkdb
 
Note: DatabaseName is the name of the database that is visible in the Job log of the failed SQL job.
For more information, see the Microsoft SQL Server documentation.
 
If default settings were used for the SQL backup job properties then run;
dbcc checkdb WITH PHYSICAL_ONLY
 
The results will show you if SQL has encountered any inconsistencies or not. If inconsistencies are encountered, please contact your SQL Administrator to resolve the inconsistencies. If the independent run of DBCC does not show any errors but when ran with the Backup job it still does, use the error listed in the error.log for SQL to determine root cause and actions.
 


          Figure 1
         Image
 
 

 

References

UMI : V-79-57344-65085 UMI : V-79-65323-3224 Etrack : 0xe0008443 UMI : V-79-57344-33859

Was this content helpful?

Article Languages