Please enter search query.
Search <product_name> all support & community content...
Article: 100031947
Last Published: 2016-02-12
Ratings: 0 0
Product(s): Data Insight
Problem
After a path is added to the Selected Data section, using a CSV (Comma-separated value) file, a red "x" appears, but the report is still able to run.Example:
1. A CSV file is added as a resource path to the Data Selection page. The entries in the CSV file are formatted without a "type" specified, as shown in Figure 1.
Figure 1 - Example of a entry in a CSV file
http://Sharepoint1/sites/Marketing |
2. From Selected Data, a red "x" appears over the path (see Figure 2).
Figure 2 - The Data Selection page, with a red "x" listed over the entry in Selected Data
Cause
A "type" is required, along with the path.Solution
When using a CSV file to import paths, specify the input type along with path name.Here are the supported path types:
- Filer
- DFSFiler
- WebApp
- DFSPathPartial
- Share
- DFSPathLink
- SiteCollection
- Folder
- Site
- File
After adding the input type to the CSV file, the red "x" is removed from path.
Example:
Add the "SiteCollection" type to the entry in the CSV file (Figure 3). The specific type will vary, depending on the entry.
Figure 3 - Example of a CSV entry, with the "SiteCollection" type added
http://Sharepoint1/sites/Marketing,SiteCollection |
Notice that a red "x" is no longer visible (Figure 4).
Figure 4 - The Data Selection page, with no "x" over the paths in Selected Data