After adding new nodes to a NBFS 3.2.100 cluster, the new nodes cannot use the tape drives that were previously configured
Problem
New nodes are not able to see, configure, or write to the tape drives that were configured prior to adding the new nodes.
Though there are new nodes without the ports/tape drives assigned, the Assign port will be grayed out and the Assigned column will indicate all nodes have the assignment.
Error Message
None
Cause
An issue with assessing the assignment state of the nodes was identified.
Solution
You must be on NBFS 3.2.100, then install the hotfix, ET4195989.
The Assigned column will then show partial and the Assign port button will allow you to assign the new nodes.
References
Was this content helpful?
Translated Content
Please note that this document is a translation from English, and may have been machine-translated. It is possible that updates have been made to the original version after this document was translated and published. Veritas does not guarantee the accuracy regarding the completeness of the translation. You may also refer to the English Version of this knowledge base article for up-to-date information.