Problem
When new RAID volume groups are created for the storage shelf, the volume information is not reflected in hardware monitoring immediately.
Error Message
The output of the show hardware-health primaryshelf component=volume command shows that volumes are not configured.
Cause
As per the current design of the storage monitoring plug-in, the inventory cycle to identify any new components runs every 24 hours. Therefore, it can take up to 24 hours to display newly created volumes.
Solution
Wait for up to 24 hours and check the volume information again.
At this time, there are no plans to address this issue through a patch or hotfix in the current or previous versions of the software. Although this issue may potentially be resolved in a future major revision, it is not currently scheduled for any upcoming release. If this issue has a significant business impact on your continued use of the product, please contact your Sales representative or the Sales team to discuss your concerns.
References
Was this content helpful?
Translated Content
Please note that this document is a translation from English, and may have been machine-translated. It is possible that updates have been made to the original version after this document was translated and published. Veritas does not guarantee the accuracy regarding the completeness of the translation. You may also refer to the English Version of this knowledge base article for up-to-date information.