During Bare Metal Restore (BMR) Final Cleanup, the error message "Unable to update client state on the Netbackup server, error =200" is displayed.
Problem
During Bare Metal Restore (BMR) Final Cleanup, the error message "Unable to update client state on the Netbackup server, error=200" is displayed.
Error Message
Unable to update client state on theNetbackup server, error=200
Cause
This error will be displayed if the restored BMR Windows client cannot contact the NetBackup Master Server to update the restore task state to Complete. The message from the client to the Maser Server is only sent once.
Possible causes are:
1. The client is not on the network. This can be caused by:
a. a host name or ip-address conflict with an existing server.
b. the network device drive was not properly installed.
c. the network settings could not be set on the client's network interface.
2. The Bare Metal Restore Master Server process "bmrd" is not operational on the NBU Master Server.
Solution
bmrd" process on the NBU Master Server is operational.
Lastly, as the task update operation is not retried after a failure, the client restore task state will be left as
Finalizing and not automatically reset. The state must be manually repaired. To do so, run the following command on the Master Server or from the restored client:
bmrc -op complete -resource restoretask -client <clientName> -status 0
Was this content helpful?
Translated Content
Please note that this document is a translation from English, and may have been machine-translated. It is possible that updates have been made to the original version after this document was translated and published. Veritas does not guarantee the accuracy regarding the completeness of the translation. You may also refer to the English Version of this knowledge base article for up-to-date information.