Veritas™ System Recovery 18 安装使用指南
- Veritas™ System Recovery 18 简介
- 安装 Veritas System Recovery
- 确保恢复您的计算机
- 入门
- 备份数据的最佳做法
- 备份整个驱动器
- 备份文件和文件夹
- 运行和管理备份作业
- 从您的计算机备份远程计算机
- 监视备份状态
- 使用 Veritas System Recovery Monitor 监视远程计算机的备份状态
- 探究恢复点的内容
- 管理备份目标
- 管理虚拟转换
- 管理云存储
- 恢复文件、文件夹或整个驱动器
- 恢复计算机
- 复制硬盘驱动器
- 使用 Veritas System Recovery Granular Restore Option
- 附录 A. 使用 Veritas System Recovery 备份数据库
- 附录 B. 备份 Active Directory
- 附录 C. 备份 Microsoft 虚拟环境
- 附录 D. 使用 Veritas System Recovery 18 和 Windows Server 2008 Core
Testing the Veritas System Recovery Disk
Veritas recommends that you create a Veritas System Recovery Disk immediately after the Veritas System Recovery 18 installation is complete and before you start running backup jobs or recovering backed-up images. If Windows fails to start or it does not run normally, you can recover your computer by using theVeritas System Recovery Disk. The drivers that are included on the recovery disk must match the drivers that are required to run your computer's network cards and hard disks.
To ensure that you have the drivers required to recover your computer, you can use the Run Driver Validation tool. The tool is available with the first Veritas System Recovery Disk that you create. The Run Driver Validation is required to identify the need for the custom Veritas System Recovery Disk and to compare hardware drivers on the recovery disk with the drivers required to run your computer's network cards and hard disks.
You should run the driver validation test any time you make changes to the network interface cards or storage controllers on a computer.
注意:
The driver validation tool on the Veritas System Recovery Disk does not support wireless network adapter drivers.
You should test the Veritas System Recovery Disk to ensure that the recovery environment runs properly on your computer.
Testing the Veritas System Recovery Disk lets you identify and solve the following types of problems:
You cannot start Veritas System Recovery Disk.
You do not have the necessary storage drivers to access recovery points on the computer.
You need information about your system to help you run Veritas System Recovery Disk.
The following table summarizes the steps for testing Veritas System Recovery Disk.
表：Testing Veritas System Recovery Disk.
Step | Action | Description |
|---|---|---|
Step 1 | Run driver validation tool | Run the driver validation tool to test whether Veritas System Recovery Disk works with the network cards and storage devices on the computer. If any drivers are not included on the recovery disk, the Driver Validation Results dialog box appears. The driver validation is added to the recovery disk during Veritas System Recovery Disk creation. To run the driver validation tool, insert the recovery disk, and go to the explorer. Without access to the correct drivers, a device cannot be used while you run Veritas System Recovery Disk. Therefore, if the recovery points are stored on a network or a local hard drive, you might not have access to them. You can find the drivers and copy them to a CD or a floppy disk. You can also create a custom Veritas System Recovery Disk. |
Step 2 | Boot your computer using Veritas System Recovery Disk | Boot your computer using the Veritas System Recovery Disk. |
Step 3 | Test the restore | Run a mock restore of a recovery point that is stored either on a network or locally on a computer. Running a mock restore helps you to test if you can restore your backup. |