Problem
After upgrading Flex appliance to version 6.0 the Flex WebUI console and SSH access to host fails to connect if mgmt0 was configured with bonding mode 802.3ad (LACP) before the upgrade.
Error Message
When attempting to connect to the Flex WebUI or attempting to access the VxOS Shell (ssh), there will be no response from the host.
Cause
The upgrade reverts the bond mode to balance-alb.
Solution
Connect to the IPMI virtual console and run the following command to set the bond mode back to LACP or whatever it used to be before:
set network bond mode=802.3ad
References
Was this content helpful?
Translated Content
Please note that this document is a translation from English, and may have been machine-translated. It is possible that updates have been made to the original version after this document was translated and published. Veritas does not guarantee the accuracy regarding the completeness of the translation. You may also refer to the English Version of this knowledge base article for up-to-date information.