Using the 'Set-BEFullBackupTask' command in a Backup Exec Management Command Line Interface (BEMCLI) script, will generate an error and not process correctly.
Set-BEFullBackupTask : A parameter called DeleteSelectedFilesAfterSuccessfulBackup with type BackupExec.Management.CLI.BEDeleteFilesAfterSuccessfulBackup was not found in the parameter set called BackupJobDefaultsParameterSet
At line:1 char:59
+ Get-BEBackupJobDefault BackupToDisk | Set-BEFullBackupTask <<<< -Name * -Storage "Any disk storage" | Save-BEBackupJobDefault
+ CategoryInfo : NotSpecified: (:) [Set-BEFullBackupTask], ArgumentException
+ FullyQualifiedErrorId : UnhandledClientException,BackupExec.Management.CLI.Commands.SetBEFullBackupTaskCommand
Set the Job defaults in the Backup Exec Console, using the 'Configuration and Settings - Job Defaults' menu options.
Symantec Corporation has acknowledged that the above-mentioned issue is present in the current version(s) of the product(s) mentioned at the end of this article. Symantec Corporation is committed to product quality and satisfied customers.
There are no plans to address this issue by way of a patch or hotfix in the current or previous versions of the software at the present time. However, the issue is currently scheduled to be addressed in the next major revision of the product. Please be sure to refer back to this document periodically as any changes to the status of the defect will be reflected here. Please note that Symantec Corporation reserves the right to remove any fix from the targeted release if it does not pass quality assurance tests. Symantec's plans are subject to change and any action taken by you based on the above information or your reliance upon the above information is made at your own risk.
Please contact your Symantec Sales representative or the Symantec Sales group for upgrade information including upgrade eligibility to the release containing the resolution for this issue. For information on how to contact Symantec Sales, please see http://www.symantec.com