SCSI-3 Persistence Reservation indicates NO for a storage array configured for SCSI-3


When viewing storage arrays in Veritas Enterprise Administrator (VEA) under a DSM (VERTIAS DMP Device Specific Module) the column for SCSI-3 Persistence Reservation may indicate NO when it is known the storage array is configured to accept SCSI-3 reserveration commands. 

Error Message


The setting in VEA gui indicates whether SCSI3Support ("SCSI-2 to SCSI-3") translation mode has been enabled within DSM via registry and not the setting on the array or reservation status of any disks from the array.  SFW 5.1 and above no longer displays SCSI-3 reservation status of disks in the VEA gui. 


The setting does not indicate a failure to set the storage array for SCSI-3 PGR and is independant of any requirements to do so. 

There are two modes of SCSI in VEA:

• DSM “SCSI-2 to SCSI-3” translation mode is used where the application (for example Microsoft Cluster Server 2003) is using SCSI-2 mode, and SFW DSM translates the SCSI-2 to SCSI-3 related reservation in order to allow I/O to use multiple paths on SCSI-3 capable storage.  This is set from the registry and is not related to “SCSI-3 mode” setting in VEA.  (Refer to the SFW Admin guide for more details.)

• VEA "SCSI-3” mode issues SCSI-3 command directly to a DG cluster disk.  There is no need to for a DSM to do “SCSI-2 to SCSI-3” translation with this setting.  This SCSI-3 mode is not related to DSM “SCSI-2 to SCSI-3” translation mode.

Applies To

Storage Foundation for Windows 5.1 and above

Storage Foundation for Windows HA 5.1 and above

Terms of use for this information are found in Legal Notices.



Did this article answer your question or resolve your issue?


Did this article save you the trouble of contacting technical support?


How can we make this article more helpful?

Email Address (Optional)