Tape Device BUFFER SIZE selected value is not saved in the Backup Exec 2012 User Interface

Problem

Tape Device BUFFER SIZE selected value is not saved in the Backup Exec 2012 User Interface

Cause

If the buffer size is set higher than the max block size, then it reverts to 1K upon the next UI start. Refer : TECH69559 to determine the maximum allowable block size for a tape drive

Solution

This Issue is now fixed with Backup Exec 2012 Service Pack 1 (TECH186717)


Terms of use for this information are found in Legal Notices.

Search

Survey

Did this article answer your question or resolve your issue?

No
Yes

Did this article save you the trouble of contacting technical support?

No
Yes

How can we make this article more helpful?

Email Address (Optional)