In PureDisk 6.6.x, running the Storage Pool Configuration Wizard under certain conditions may overwrite and reinstall the PureDisk environment.

  • Modified Date:
  • Article ID:000010831



When using the Storage Pool Configuration Wizard while topology files are corrupted or missing, running the wizard could result in a reinstallation of the PureDisk environment which would completely overwrite the existing environment, rendering it unusable and unrecoverable.



The formal resolution to this issue (Etrack 2227601) is scheduled to be included in a future release of PureDisk.

Verify the contents of the topology_nodes.ini file before using the Storage Pool Configuration Wizard.

If this workaround is unfeasible, please contact Symantec technical support, referencing this document ID and Etrack 2227180 to obtain an Emergency Engineering Binary (EEB) replacement library containing a fix for this issue.

Note: This fix adds a warning dialogue to the GUI and allows an opportunity to abort the wizard. However, it does not resolve any issues regarding the underlying corruption in the topology information. To resolve these issues, please contact Symantec technical support.

Best Practices:
Symantec strongly recommends the following best practices:
1. Always perform a full DR backup prior to making any changes to your environment.
2. Always make sure that your environment is running the latest version and patch level.
3. Perform periodic "test" restores.
4. Subscribe to technical articles.

How to Subscribe to Email Notification:
Directly to this Article:
Subscribe to this article by clicking on the Subscribe via email link on this page to receive notification when this article is updated with Release Information.

Software Alerts:
If you have not received this TechNote from the Symantec Email Notification Service as a Software Alert, you may subscribe via email and/or RSS using the links provided at the following page:


Applies To

What is Affected:
This issue affects the following versions of NetBackup PureDisk:

  • 6.6
  • 6.6.0.x (all versions)
  • 6.6.1

How to Determine if Affected:
Check the size and contents of the topology_nodes.ini file by running either or both of the following commands:
# ls -l /Storage/etc/topology_nodes.ini
# cat /Storage/etc/topology_nodes.ini

If this file is found to be empty, running the Storage Pool Configuration Wizard will result in a re-install of the PureDisk environment.


Terms of use for this information are found in Legal Notices.



Did this article answer your question or resolve your issue?


Did this article save you the trouble of contacting technical support?


How can we make this article more helpful?

Email Address (Optional)