Upgrading the dynamic disk group version
Product: SFW HA
The dynamic disk group version is not upgraded after you upgrade SFW or SFW HA. If a service group in the previous configuration contains a dynamic disk group, you must upgrade its version after you complete the SFW or SFW HA upgrade.
You can upgrade the dynamic disk group, using the Veritas Enterprise Administrator (VEA) console or the CLI.
To upgrade the disk group, using CLI, run the following command. You must run this command for each dynamic disk group separately.
vxdg -gDynamicDiskGroupName [-T version] upgrade
DynamicDiskGroupName= Name of the dynamic disk group
version= Target version of the dynamic disk group
After the disk group version is upgraded, run the following command to verify the upgraded version.
vxdg -gDynamicDiskGroupName dginfo
Perform the following steps to upgrade the dynamic disk group version, using VEA. You must perform these steps for each dynamic disk group separately.
To upgrade the dynamic disk group version, using VEA
From the VEA console, right-click the disk group.
A notification indicating that the disk group version has been upgraded is seen in the alert logs. You can also verify the disk group properties to confirm the upgraded version.