Veritas Dynamic Multi-Pathing Release Notes

  • Modified Date:
  • Article ID:000076629


Veritas™ Dynamic Multi-Pathing Release Notes


1. Dynamic Multi-Pathing Release Notes
About this document
About Veritas Dynamic Multi-Pathing
About Symantec Operations Readiness Tools
Important release information
System requirements
Hardware compatibility list
Supported HP-UX operating systems
Veritas Storage Foundation memory requirements
Software limitations
DMP settings for NetApp storage attached environment
LVM volume group in unusable state if last path is excluded from DMP (1976620)
Known issues
Warnings appear during installation processes when VxVM root support is enabled (2018730)
Issues with ALUA arrays that support standby Asymmetric Access State (AAS) when using EFI disks on HP 11.31 (2057649)
DMP not supported with LVM 2.2 (2071691)
DMP path discovery behavior when a device is removed from PowerPath control (2144891)
Path name character limit when converting LVM volumes over DMP to VxVM volumes over DMP (2035399)
I/O fails on some paths after array connectivity is restored, due to high restore daemon interval (2091619)
Changes in enclosure attributes are not persistent after an upgrade to VxVM 5.1 SP1 (2082414)
Enclosure name limitation when using HP-UX LVM pvcreate command on DMP device
Adding a DMP device or its OS device path as a foreign disk is not supported (2062230)
Issues related to installation
Documentation set
Manual pages

Terms of use for this information are found in Legal Notices.



Did this article answer your question or resolve your issue?


Did this article save you the trouble of contacting technical support?


How can we make this article more helpful?

Email Address (Optional)